Last Modified: 11-29-2007 1.6 A
Service Category: Vehicle Exterior Section: Exterior Panels/Trim
Model Year: 2008 Model: Sequoia Doc ID: RM0000023C0006X
Title: EXTERIOR PANELS / TRIM: BLACK OUT TAPE (for Rear Door): REMOVAL (2008 Sequoia)

REMOVAL

HINT:

  • Use the same procedure for the RH side and LH side.
  • The procedure described below is for the LH side.

1. REMOVE REAR DOOR WINDOW FRAME REAR MOULDING EXTERIOR PANELS / TRIM: REAR DOOR WINDOW FRAME MOULDING: REMOVAL (2008 Sequoia)+

2. REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP EXTERIOR PANELS / TRIM: REAR DOOR BELT MOULDING: REMOVAL (2008 Sequoia)+

3. REMOVE REAR DOOR FRAME GARNISH

HINT:

Use the same procedure as for the RH side DOOR / HATCH: REAR DOOR: DISASSEMBLY (2008 Sequoia)+ .

4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

HINT:

Use the same procedure as for the RH side DOOR / HATCH: REAR DOOR: DISASSEMBLY (2008 Sequoia)+ .

5. REMOVE REAR DOOR ARMREST BASE UPPER PANEL

HINT:

Use the same procedure as for the RH side DOOR / HATCH: REAR DOOR: DISASSEMBLY (2008 Sequoia)+ .

6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

HINT:

Use the same procedure as for the RH side DOOR / HATCH: REAR DOOR: DISASSEMBLY (2008 Sequoia)+ .

7. REMOVE REAR DOOR GLASS RUN

HINT:

Use the same procedure as for the RH side DOOR / HATCH: REAR DOOR: DISASSEMBLY (2008 Sequoia)+ .

8. REMOVE NO. 2 BLACK OUT TAPE

(a) Using an infrared light, heat the No. 2 black out tape.

CAUTION:

Do not burn yourself on the hot rear door panel or with the infrared light.

HINT:

Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

(b) Lift the end portion with your nail and peel it parallel to the attachment surface.